METAR TAF 3D
Crosswind calculator
Live map

Crosswind Calculator

Work out the headwind, tailwind and crosswind for any runway. Enter the numbers yourself, or type an airport's ICAO code to use its live METAR and every runway at once.

From an airport's live METAR

Manual calculation

The formula

Take the angle between where the wind is coming from and the runway heading. Then:

ComponentFormulaExample: wind 240°/20 kt, runway 27
Anglewind direction − runway heading240° − 270° = −30° (from the left)
Crosswindspeed × sin(angle)20 × sin 30° = 10 kt from the left
Headwindspeed × cos(angle)20 × cos 30° ≈ 17 kt headwind

A negative headwind is a tailwind. Runway numbers are the magnetic heading rounded to tens of degrees, so runway 27 is roughly 270° magnetic, while METAR wind is given relative to true north. Where the variation is several degrees, correct one of them before comparing. The full method, including runway selection and gusts, is in Crosswind component calculation and runway selection.

The clock method

For a quick check in the cockpit, treat the angle like minutes on a clock: 15° off is a quarter of the wind speed as crosswind, 30° is half, 45° is three quarters, and 60° or more is practically the full wind. Wind 240° at 20 kt on runway 27 is 30° off, so about 10 kt of crosswind.

Live runway diagrams

Every airport page draws the runways with the current wind and the components for each end: EGLL London Heathrow · KSFO San Francisco · LTBS Dalaman · EDDF Frankfurt · LFPG Paris CDG · OMDB Dubai. You can also paste a raw report into the METAR & TAF decoder.

Advertisement

Frequently asked questions

How do you calculate the crosswind component?

Crosswind = wind speed × sin(angle between the wind and the runway). Headwind = wind speed × cos(the same angle). With wind 240° at 20 kt on runway 27 (270°) the angle is 30°, so the crosswind is 20 × 0.5 = 10 kt from the left and the headwind is 20 × 0.87 ≈ 17 kt.

Is METAR wind true or magnetic?

METAR and TAF winds are relative to true north. Runway numbers, ATIS and tower winds are magnetic. Where the magnetic variation is large, enter it in the calculator so the runway heading and the wind are compared on the same reference. In airport mode the calculator uses each runway's true heading, so no correction is needed.

Should I use the gust or the mean wind?

Both. The mean wind gives the steady component; the gust gives the peak you have to be able to hold. Many operators compare the gust crosswind with the aircraft's maximum demonstrated crosswind, and add half the gust factor to the approach speed.

What is a quick mental method?

The clock method: 15° off the runway is a quarter of the wind as crosswind, 30° is half, 45° is three quarters, and 60° or more is practically all of it. It slightly overestimates at 45°, which errs on the safe side.

What is the maximum demonstrated crosswind?

It is the highest crosswind at which the aircraft was shown to be controllable during certification, published in the flight manual — for example 15 kt for a Cessna 172. It is not a hard legal limit, but exceeding it means you are testing beyond what the manufacturer demonstrated.